Aires continues to produce some highly detailed and attractive sets for the modeller who wants to build more than just out of the box.

This 1/48 scale set has been produced for the Tamiya P-51B/C kit to display a full exposed Rolls Royce engine.

The set comprises 27 crisply cast light grey resin detail parts and 2 lengths of wire. The set contains the engine and ancillary parts as well as all of the mounting assembly and cowlings. The parts have easy to remove moulding blocks but care will be needed when handling so as not to damage the fine detail.

First of all, some extensive surgery is required to remove the kit nose area and this has been explained on the instruction sheet with the area to be remove shaded. Fortunately this falls along heavily recessed panel lines, so no rocket science is needed in measuring for the cutting. Some thinning of the kit is required where the firewall is to be located. The lower rear cowl remains as a part of the kit and this will need some internal thinning and cleanup. Enthusiasts may want to add some extra detail here as some of the inner cowl will be visible when the engine is fitted.

The engine is made up of 3 major parts - the block, sump and supercharger. To this are added some smaller components such as the oil filter, main propeller drive shaft and various plumbing. The detail on the engine is excellent with all of the detail crisply moulded, even the ignition harness stands proud and looks three dimensional.

The engine firewall is similar and abounds in detail. The prominent features being the glycol coolant reservoir and associated wiring. The main engine bearers mount directly to the firewall encasing the engine onto two sturdy mounting points on each side. The supercharger inlet ducting mounts directly from underneath to the engine and engine bearers and captures all the detail of the wiring harness, oil and coolant plumbing. The oil reservoir and front plate fit onto the front of the engine bearers completing the main assembly of the kit.

To complete the full assembly some plumbing and wiring detail needs to be added before fitting the two upper cowling bearers and supports. Finally the modeller needs to select which type of exhaust pipes are required from the two options and fit them into place.

At this point the whole assembly is fitted into the model and glued in place. I think that this is the easiest process rather than try to build the assembly after the firewall has been fitted to the kit.

Last of all is the cleanup and display of the cowls. These have been provided with full internal and external detail that has been crisply moulded in full relief.

Overall this is a very extensive detail set and some moderate modelling skills will be required assemble and install the set into the kit.

Modelling Skills required - Moderate.

Recommended.

Thanks to Aires for the review sample

Text and Images Copyright © 2005 by Mick Evans
Page Created 28 November, 2005
Last updated 27 November, 2005

Back to HyperScale Main Page

Back to Reviews Page